| Year 1994 | • | Establishment
of Impressive Edge Sdn Bhd (IESB) |
| • | To
supply precisions parts to leading Multinational companies in the region. |
| Year 1996 | • | Won
the prestigious Supplier of the Year award from Infineon Technologies (Malaysia)
Sdn Bhd (formerly known as Siemens Technologies (Malaysia) Sdn Bhd) for the year
1996/1997 under spare parts and tooling categories. |
| Year
1998 | • | Moving
to larger premise located in Taman Perindustrian Merdeka, Batu Berenam, Melaka.
It is about 18766 sq. ft. |
| • | To
serve customers with excellence as the business had tremendous increase in demands.
|
| • | Obtained
ISO 9002 certifications from SGS Yarsley International Certification Bodies. |
| • | Won the
prestigious Supplier of the Year award from Infineon Technologies (Malaysia) Sdn
Bhd (formerly known as Siemens Technologies (Malaysia) Sdn Bhd) for the year 1997/1998
under parts categories. |
| • | Establishment
of subsidiary company known as Sun Component Engineering Sdn Bhd based in Penang
to focus on handling major customers at Northern region. |
| Year 2000 | • | Establishment
of brother company Impressive Edge Precision Sdn Bhd (IEPSB) |
| • | To supply precisions
parts in leading Multinational companies out of the region. |
| • | Won two prestigious
Supplier of the Year award from Infineon Technologies (Malaysia) Sdn Bhd (formerly
known as Siemens Technologies (Malaysia) Sdn Bhd) for the year 1999/2000 under
parts and consignment categories. |
| Year
2001 | • | Establishment
of Impressive Edge (Penang) Sdn Bhd to serve Northern region customers more effectively.
|
| • | Establishment
of Impressive Edge (Kuala Lumpur) Sdn Bhd. |
| • | To
supply the ultra precision pins and punches to the leading companies in the regions. |
| Year 2002 | • | Setting
up of Engineering and Research and Development (R&D) Department. |
| • | Design, R & D and
Develop of:
• 10 Units of High Precision Degating Tool
to Infineon, Melaka.
• 4 Units
of Conversion Kit for Auto Moulding System.
•
6 Units of Manual Test Fixture for Infineon, Melaka
Quality Assurance (Q.A) Laboratory. |
| Year
2003 | • | To qualify
under Infineon’s IC Mould Category, IE had satisfied the following requirements:-
• Tolerance below 5 micron
• Accurate
multiple surface finishing within a single cavity
strip.
• Thermo expansion co-efficient rate. Understanding
material expansion behavior under various heating
conditions. |
| • | Achieve
transition of ISO 9001:2000 certification. |
| Year
2004 | • | IE was listed in
Bursa Malaysia (formerly known as Kuala Lumpur Stock Exchange) on 7th December
2004. |
| • | IE
was conferred with 2 new awards from Infineon Malaysia, namely Zero Defect Award
and Best Supplier Award. |
| • | IE
finalized its new factory building plan. |
| • | IE
finalized its plan for the new business operation in China. |
